matplace
2-Tone Spiral Planter

2-Tone Spiral Planter

by Jacob Rempel · Printables

Print it for yourself

The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC (non-commercial)
Largest side
about 110 mm
Printing estimate
about 185 g of filament, 7 h 5 min
Price with us
from €18.60 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

Use either PLA or PETG INNER SECTIONS: • Vase mode/spiralized outer contour recommended OUTER SECTIONS: • No supports needed • Use settings optimized for overhangs and retractions (there are a lot of both) • A 0.6mm nozzle will reduce print times and is generally an excellent investment This planter can be used for most plants. I don't recommend super thirsty plants, however, as the drainage area is small. It is best to plant in the inner section BEFORE putting it into the outer section, and it's wise to fill the narrow bit with pebbles for drainage.

Similar models