matplace
2-Tone Spiral Planter

2-Tone Spiral Planter

autor Jacob Rempel · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 110 mm
Odhad tisku
asi 185 g filamentu, 7 h 5 min
Cena u nás
od 465 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Use either PLA or PETG INNER SECTIONS: • Vase mode/spiralized outer contour recommended OUTER SECTIONS: • No supports needed • Use settings optimized for overhangs and retractions (there are a lot of both) • A 0.6mm nozzle will reduce print times and is generally an excellent investment This planter can be used for most plants. I don't recommend super thirsty plants, however, as the drainage area is small. It is best to plant in the inner section BEFORE putting it into the outer section, and it's wise to fill the narrow bit with pebbles for drainage.

Podobné modely