Sanding Wedge V2
MakerWorld · ralf.hoerhager
by PrismaPrints · Printables
The licence of the model (CC BY (attribution)) allows commercial use too. Download the file at the source and upload it to us. We note the author and the source on the order for you.
Upload the file and printThis is a three part sanding block, made to be very easy to put together. Scale as you like, but be wary when scaling down, the bolt may need more clearance. At 100% scale needs about 19cm of sandpaper. Recommended settings (best to use PLA+ or PETG) Main block: 20% infill or more, 0.2mm layer, no supports needed Bolt: use 40% infill, ideally PETG, 4 wall lines, 0.1mm layer. Wedge: Use whatever settings None of the parts require supports. The clearance test is used to figure out if there's enough clearance without wasting material.
MakerWorld · ralf.hoerhager
MakerWorld · RuiRaptor
MakerOnline
Printables · EmGi
MakerOnline · Fulop Huba
Printables · Gimme Ya Model
MakerOnline
Printables · Many24
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies