matplace
Raspberry Pi NAS Enclosure - Dual SSD 2.5"

Raspberry Pi NAS Enclosure - Dual SSD 2.5"

MakerWorld

Print it for yourself

The licence (personal use only) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
personal use only

About the model

Hey everyone! I just started getting into electronics and design after a bit of 3D printing. This is my first official project with proper documentation, measurements, and testing around a Raspberry Pi. The design is purposeful where the SSDs stick out and with cables going around, wrapped in a cable sleeve for an interesting look. The OLED helps to monitor the device and to check ip. Updates: • 9/22/2023: Initial release Parts used: • 1x Raspberry Pi 4B 2gb • 1x OLED 0.96 i2c display module • Required cables (ethernet, power cable, etc.) • 1x 60mm 5v USB fan • 2x USB to SATA cable • 2x SSD 2.5" • 2x M3 14mm-16mm screw • 23x M3 6mm screw • 25x M3 4mm screw • 2x M3 nut https://www.amazon.com/Sabrent-2-5-Inch-Adapter-Optimized-EC-SSHD/dp/B011M8YACM/ref=sr_1_4?crid=XHDE9KMMJRLB&keywords=sata%2Bto%2Busb%2Bconnector&qid=1695431511&s=industrial&sprefix=sata%2Bto%2Busb%2Bconenctor%2Cindustrial%2C86&sr=1-4&th=1 All up to you but this is how I printed mine: • Printer: Bambu Lab P1P & Elegoo Neptune 3 Plus - for the inner panels • Some adjustments have to be made in terms of the base • Walls: 4 • Top/bottom: 4 • Nozzle: 4mm • Layer height: 0.16mm • Infill: 15-20% - any pattern • Supports: ON for outer panels - tree • Brim: ON for outer panels Here are some assemblies to help install and notes: • SSD side bracket is to be mounted inside, keeping the 2 SSDs in place • 60mm USB fan apparently can't be controlled so I'd recommend an adapter with a physical knob attached • There are 3 versions of Front Panel Outer for OLED, no OLED, and additional airflow. • SSD top panel bracket only needs 2 screws for SSD on the top as it's stable enough Please leave any comments/feedback as they would be greatly appreciated!

Similar models