matplace
PARKSIDE Powerfix Clamp Replacement Jaw

PARKSIDE Powerfix Clamp Replacement Jaw

by Nikodem Bartnik · Printables

Print it for yourself

The licence (CC BY-NC-SA (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC-SA (non-commercial)
Largest side
about 85 mm
Printing estimate
about 28 g of filament, 2 h 22 min
Price with us
from €5.40 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

Don't throw away your broken clamps! This is a heavy-duty replacement jaw for the Powerfix Profi+ one-handed clamps (commonly sold at Lidl), though it is designed to be compatible with many similar "budget" quick-grip clamps found at hardware stores. This model is a direct drop-in replacement. It is designed to reuse all your original hardware, including: • The original mounting screw and nut. • The original red rubber protective pad. Print Settings To ensure the part can handle the clamping force without delaminating, I recommend the following "overbuilt" settings: • Material: ABS or ASA (recommended for strength and slight flexibility). PETG is a good secondary choice. • Wall Loops: 6 (Essential for structural integrity around the bolt hole). • Infill: 50% (Gyroid or Cubic recommended). • Layer Height: 0.16mm (Provides better surface area for layer adhesion). • Supports: Yes (Required for the internal nut housing and overhangs). • Orientation: Print on its side for maximum strength (avoids the clamping force pulling against layer lines).

Similar models