Star Wars (Inspired) "Mando Fandalorian" HueForge Mandalorian Helmet
MakerWorld · Chris Pirillo
by Roary Labs · Printables
The licence (CC BY-NC-SA (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printThis is a medal holder that you can hang on your wall. Is made out of 5 parts, that can be mounted without glue or screws, just interference (there is a lot of interference, but if you push enough, you will be able to assemble it). If you have difficult sliding it in the lower part, use a little bit of oil lube and a rubber hammer. You must print it using SUPPORTS, between the parts where the 5 pieces are going to join. Be careful, remove all the excess otherwise you are going to have problems while mouting it. To hang on the wall you need this type of hooks: https://lc.cx/IwnjzK Credit to https://www.klipartz.com/it/sticker-png-bzwko for the figures used in this design If you have problems, contact me! If you like it, leave a like and a comment, thanks :)
MakerWorld · Chris Pirillo
Printables · Teo_211
Printables · Sam Lansink
Printables · Raavhimself
MakerOnline · HueForgeMaster
Printables · VectorHunt
Printables · AlDente-Lab
MakerWorld · minivanbuzz
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies