matplace
Loud and compact Whistle for your Keychain

Loud and compact Whistle for your Keychain

by ThreeD-Michael · Printables

Print it for yourself

The licence (personal use only) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
personal use only
Largest side
about 65 mm
Printing estimate
about 8 g of filament, 32 min
Price with us
from €3.40 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

News 2024-03-17:My newest whistle design, a Long Range Dog Whistle at 7,000 Hz. Please download here.News 2024-01-21:I designed an ultrasonic dog whistle with an even higher pitch of 23 kHz, which you can download here.Update 2023-02-15:I have also designed a gift and storage box for these 3 whistles, which you can find here.SummaryI needed a load and compact whistle to fit my keychain and couldn't find any design which fits my requirements. What I found was either too bulky, too fragile, or too quiet.So I made my own design, and this are the key advantages:extremely loud for it's size,very compact, only 5 mm thick, 14.3 mm wide and 48.9 mm long,double tone, sounds similar to a referee's whistle,easy to blow,sturdy and hard to destroy,lean design,easy to print,fast printing (< 20 min), little filament required (approx. 2.5 grams).And I added 2 more variants of this whistle:an even slimmer version with 4 mm thickness that fits in your wallet,a variant with a lower pitch.How to print:Use a line width of 0.4 mm and a layer height of 0.2 mm, 4 top layers and 4 bottom layers.The whistle requires correct positioning of the Z-seam - it shouldn't be placed in the narrow air passages inside the whistle. The Z-seam should be positioned as shown in the image above (the white dots represent the Z-seam). Use the “Z Seam Alignment: User specified” option in Cura or the "Seam Painting" option in PrusaSlicer to achieve this.If you are using Cura I recommend V4.13.1 for this design as Cura 5.x still has problems placing the Z-seam.Print slowly to achieve sharp edges.If you want a multicolor print as in the picture above, change filament at the desired height.Do you like it?If you have printed this design and you like it, I would be happy if your make is uploaded.Please also check out my Steam Train Whistle and my Valentine Whistle:

Similar models