matplace
Honeycomb monitor stand

Honeycomb monitor stand

by Erl · Printables

Print it for yourself

The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC (non-commercial)
Largest side
about 480 mm
Printing estimate
about 320 g of filament, 13 h 0 min
Price with us
from €32.20 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

Simple honeycomb end pieces I made for a monitor stand. Dimensioned for 1.5 cm thick plywood or similar. About 17.5 cm deep. I uploaded a version without and two versions with brackets. I also made a middle brace that can be put in the back to avoid sagging shelves if you make it very wide. Print instructionsI upped the bed temp to try to avoid warping in the corners. You can also try to warm the bed longer before printing to ensure it is properly warm all over, and print in an enclosure. I printed in PETG to avoid sagging on a hot summer day, and used three perimeters for added strength.

Similar models