matplace
Fred The Frog, but a large magnetic container

Fred The Frog, but a large magnetic container

MakerWorld

Print it for yourself

The licence (personal use only) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
personal use only

About the model

I wasn't sure about printing the existing screw-fitting Fred container at large size and I thought it'd work well using magnets to attach the lid. This is created from the “resculpted” version of Fred the Frog. It requires eight 6x2mm magnets which should “push” fit into the holes with a tiny bit of force and then hold. If not you may need to widen the holes slightly and/or use a tiny dab of glue on the magnet. To print it smaller you'd need to replace the magnet holes. I originally intended to create a lip around the hole which would fit into a recession in the head for additional stability, but meshmixer did not want to co-operate.

Similar models