Game Controller Holder
Printables · GreenBit
by PolygonBronson · Printables
The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printHere is a statue headphone stand that was inspired by the classic marble sculptures of the renaissance. When I had the idea for this I couldn't find anything online that was similar, so I made it myself. This probably wouldn't be a good stand for a high-clamp headphone since the pads would dig into the arms/dress. It's also sized for large, over ear headphones. The headphones pictured is a Monolith M1070 (fully extended). The stand is in 3 different pieces, all in PLA, both to fit my printer and print most optimally. The pieces are the headband rest bow (the curved top part), top, and bottom, with pegs/holes for putting them together. Tolerances were good enough on my Ender 3 V2 that that they fit as printed (YMMV), but they could wobble a bit, especially where the top and bottom section meet so I used some gel super glue to make everything more stable. I also split it into 3 pieces to minimize the supports and so the bow could be printed the strong way (on the edge). I used a brim for the bow and top pieces to make sure they didn't come off while printing. The bottom is so huge build plate adhesion shouldn't be a problem. The headband rest needs build plate supports, but just for the hand blocks. You don't need them for the holes in said blocks. I printed this piece at 0.2mm and 15% infill. The top needs build plate supports for the end of the hair and her left breast (this one isn't strictly necessary, I think) and if printed at 0.12mm it can print everything else, including the arms (it's right at the max 59 degrees that Cura allows) without supports which saves loads of plastic. I think I printed this piece at 15%, but you could get away with less, I just wanted it to fill solid. Don't crank the printing speed too high or the fingers and other small details might fail. I had some stringing and blobbing on the fingers and had to do some finish work to clean those up. The bottom will take a loooooooong time to print no matter what settings you use. This piece took me 26 hours at 75mm print speed. I used the adaptive layer setting in Cura that ranged from 0.12mm to 0.28mm (0.2 + or - 0.08mm in 0.04mm steps). This helps the speed of printing the middle section but makes sure the curves at the bottom and details on the belt are nice and fine. I did line infill of 5% but you could save plastic printing but using like a 10% lightning pattern but it would be very hollow-sounding which I was trying to avoid. Definitely not a print for the faint of heart, but it's a pretty cool conversation piece when it's done! :)
Printables · GreenBit
MakerWorld · RemcoGoy
MakerWorld · CitySideGig
Printables · Michael Seaton
Printables · Artemix
Printables · TriDimen Studio
Cults3D · 3Rdesign
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies