Anubis pen holder
Printables · Pomeranč
by Chris (Aero)Engineering Design · Printables
The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printContemporary business card holder angled at 45° for a stylish display of your business cards. This display can hold cards of any size. Cards in the 85x55mm format sit flush with the outside of the stand. The stack of cards can be up to 15mm thick. I remixed this model from Titafubaki and added a undercut at the bottom where the edge of the cards go. This allows even rectangular cards to lay flat on the sides and the corners do not bend. Printing If your printer can handle 45° overhangs, this model can be printed without supports. My Ender 3 V2 Neo, which struggles a bit with steep overhangs, printed this very cleanly (see pictures). Make sure “Ensure vertical shell thickness” is enabled on Pruce Slicer version earlier than 2.6 (it's default, not switchable behavior after that), so you get nice angled surfaces. I used the following printer parameters: • 2 perimeters, 20% cubic infill • 0.2mm layers • 1mm solid bottom layer thickness In Prusa Slicer 2.6 and higher, you can also easily add text to the foot, which is a great way to personalize the holder. You can of course also increase the solid bottom layer thickness, so that the stand becomes a little heavier at the bottom. But this is not necessary for stability, because the holder is quite stable.
Printables · Pomeranč
MakerWorld · Laura12
Printables · Pippa
Printables · Peterson Daughtry
Printables · Andreas Jäde
MakerOnline · fifindr
Printables · HribaDesign
Printables · LV3D
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies