matplace
Another Filament Dry Box (with printable PDF drill guides)

Another Filament Dry Box (with printable PDF drill guides)

by ckflyer · Printables

Print it for yourself

The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC (non-commercial)

About the model

A basic filament box capable of holding 4 spools of filament. These files provide the basics to build the spool holder and a few extras. The rest you can really build how ever you like. If you want to build it exactly as I have, you will need the materials below. VERSION 2: Changes: • Made the design a little simpler to use • Spool rod is not locked into place. Just slides in and out for easier removal, but will still be retained in place • Slightly modified Feeding and Return nuts • I am working on a system to eliminate tangles and filament jumping over spool walls. If I finish it, this will be the version it will be based on • All print guides and hardware stay the same in version 2 Features: • Hygrometer for temperature and humidity levels • Individual bowden tubes for each roll • Choose to feed the filament out the top or bottom • Gasket sealed box • Printable PDF drill guides so there is no guessing Files: • Complete Part File - all the parts needed in the correct orientation as I have built this box • Spool_Hygrometer - one side of the spool holder with included hygrometer mount. If you don't want the hygrometer print two of the “Spool” files • Spool - one side of the spool holder • Feeding Nut - this has a smaller hole to allow feeding of the filament from the inside of the box. Goes on the back of the bowden tube pneumatic fittings. • Return Nut - this nut has a larger hole in the back to allow storage of the loose end of the bowden tube when not in use. Goes on the back of the bowden tube pneumatic fittings. • Plug - used to keep air out of the box when one of the spools is in use. Just plug it into the pneumatic fitting from the outside. • Baffles - a file made by nscale to help prevent tangles can be found here • Desiccant Box - a desiccant box designed specifically for this dry box. Two of them should fit nicely under the spools. Parametric version can be found here Required Materials: • 8 M3x10 screws and nuts - https://amzn.to/3FP6AHA • About 12.5 inches of ¾ inch PVC • 8 bowden tube pneumatic fittings - https://amzn.to/43R9Rht • 2 ft of 2mm ID bowden tubing - https://amzn.to/45OYr0k • Hygrometer - https://amzn.to/4kTTTdo • Desiccant Pack - https://amzn.to/43Rjvkg • Storage Tote - Sterilite 20qt gasket tub - https://www.walmart.com/ip/Sterilite-20-Quart-Gasket-Box-Weather-Resistant-Clear-Storage-Bin-with-Lid-Blue/39916455?classType=VARIANT&athbdg=L1103&from=/search Few notes on the supply list; These are affiliate links to the exact materials I bought and they all seem to be good purchases so far. The desiccant pack is probably a little over kill but works very well. I bought two, you really only need one. Also, this project is designed around the Sterilite tub linked above. I think amazon has it but it is only $7 at Walmart. Print Settings: Nothing real complex here. I printed at 15% infill with basic settings. I might increase the infill for the base around the 'C' shaped parts and I would maybe do 100% infill on the plug and nuts. Everything else is as normal.

Similar models