"Waves" Designer Lamp
autor JH · Printables
Máte soubor? Vytiskněte ho na naší tiskárně
Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.
Nahrát soubor a vytisknout- Licence
- CC BY (s uvedením autora)
- Největší rozměr
- asi 110 mm
- Odhad tisku
- asi 145 g filamentu, 6 h 20 min
- Cena u nás
- od 394 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.
O modelu
Designer-Esque fully 3D-printable Vasemode Lamp Design The Lampshade and the base thread into each other for a seamless and sturdy appearance. Although it is designed to fit the Bambu Labs "LED Lamp Kit" you can easily modify the Base to fit any light source (details see below). Printing Instructions (settings already implemented in .3mf files) Lampshade: The first 6mm of the Lampshade is the part that screws into the base and therefore is designed to be printed solid (achieved by enabling solid bottom layers). From there on upwards is the actual Lampshade that is ideally printed with Vasemode. For these settings proceed as followed: • Select preferred layer height (0.2mm recommended - as seen in pictures) • Enable Vase Mode • Set External Perimeter Extrusion Width to 0.6mm • Set solid bottom layers for the first 6mm • 0.10mm layer height = 60 solid bottom layers (59 if first layer is still 0.2mm) • 0.15mm layer height = 40 solid bottom layers • 0.20mm layer height = 30 solid bottom layers • 0.24mm layer height = 25 solid bottom layers • 0.30mm layer height = 20 solid bottom layers Base: • 0.2mm layerheight • 10% rectilinear infill • 2 Perimeters • As seen in Pictures: Fuzzyskin for the most outer cylinder to 0.3 thickness and 0.4 point distance Assembly Instructions (Bambu Labs LED Lamp Kit) • Remove any debris from the bottom 3 holes of the base and glue the feet into place (e.g. with superglue). • While waiting for the glue to set check the threads of the Base for any imperfections and remove those (e.g. with a sharp knife). • Disassemble the LED light source from the Bambu Labs LED Lamp Kit by unscrewing the two metal body halves counterclockwise. • Attach the bottom part of the LED light source to the base with the included screws or double sided tape. • Screw the top half of the LED light source back again onto the bottom half that is now attached to the base from step 4. • Carefully screw the lampshade into the base. If it has too much resistance, ch
Podobné modely
Christmas cat lamp
matplace
Dragon lamp
matplace
Space Table Lamp
matplace
Deadspace+Marker+Lamp
matplace
Christmas Tree now with lamp base
matplace
