matplace
StrongArm:   A Table & Desk holder (hook) for bags and purses and headphones

StrongArm: A Table & Desk holder (hook) for bags and purses and headphones

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 110 mm
Odhad tisku
asi 42 g filamentu, 1 h 38 min
Cena u nás
od 130 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Update: 2/8/2023 : Added a variant with an even stronger total load capacity by addressing the weakest bend in the first model, but you can't push it quite as far into a desk because of the curve. See “Variants” for which one to print. Why I made this I wanted a strong portable hook to hang bags or purses from a table. I looked at some existing hooks but when printed in PETG I found them to be somewhat weaker than expected, even when printed in multiple perimeters. Some other models looked a little stronger, but demanded you use a table of limited thickness and exerted forces in ways that might make the holders prone to slipping or scratching table surfaces if printed in certain filaments. I took an existing model and re-modeled it from scratch with my own modifications in Fusion 360, conducting a crude FEA to determine where it was weakest and adding mass and smoothing to those areas to spread the strain out. How to print this • I recommend adding 100% infill modifiers (as shown in the pictures) to reinforce the weakest points as determined by a crude FEA analysis in Fusion 360. These points appear to be the two bends shown. • I used 40% gyroid infill and 5 perimeters at a layer height of 0.2 mm and top/bottom thicknesses of a minimum of 1.0 mm solid infill. This strengthens the model significantly. • For people using Bambu Slicer, I've included a 3MF project with the suggested 100% infill modifiers pre-placed and a setup to print in Prusament PC-CF. • You can use any filament you'd like , but do be aware that strength and breakage mode at failure (bend vs shatter) will vary significantly with filament choice. If you're expecting a lot of load on the hook, I'd recommend printing with something like good quality PLA or Polycarbonate Carbon Fiber which have high tensile strengths. Be aware, however, that many PLAs will creep with load over time. • Supports not required (print on the side).   Performance • This improved model should handle at least ~10 lb

Podobné modely