matplace
Stable Flyer VI - Small Toy Glider

Stable Flyer VI - Small Toy Glider

autor João Hackbart · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 110 mm
Odhad tisku
asi 12 g filamentu, 45 min
Cena u nás
od 85 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

NOTE: After reading this paper on the effect of Tail Dihedral on stability, and experimenting on my design, it seems that it is a great idea to angle the Horizontal Stabilizer into a negative dihedral (anhedral). Or in other words, for even smoother flying, slightly bend the horizontal stabilizer into an inverted V.       Intro Inspired by other single piece gliders like Stratos Glider and Bukobot Fly. This is a one piece ready-to-fly toy glider. Made to be thrown by hand, like a dart.  Now with an adjustable elevator, allowing easier trimming for a perfect glide ratio.   You can also check the remix from JoeRixon here.   Stable Flyer VI LIGHT After taking into consideration some very valuable suggestions from Stuclik over in the comments, I've designed a lighter version with a detachable vertical stabilizer. Perfect for throwing indoors, since with a weight of only 6g in PLA it has a very low impact energy, making sure no TVs or portraits get broken.   Steps to Fly   • Print with the desired infill.   • Bend its wings slightly up.   • Adjust the elevator at the tail   • Hold it between the wing and the tail and throw it!       Infill The infill will affect the weight of the glider's nose. 15% provides the closest to neutral stability with PLA. The difference between 0% Infill and 100% Infill can be seen in the shift of the position of the Center of Gravity. This, in turn, affects the flight characteristics of the glider.      As a fun experiment, try to print it with 10% Infill and 100% Infill, then throw both and try to understand how the shift in the C.G affects the way it glides.       ONLY SCROLL DOWN IF YOU ARE BORED AND CURIOUS.           Aircraft Design - Tail Sizing   In order for an aircraft to be stable, there has to be a precise relation between the size of its wing and the size of its empennage (vertical and horizontal stabilizers AKA Tail). By measuring the different dimensions in the image above we are ab

Podobné modely