matplace
Romac+ (Romac Plus) Macropad Case

Romac+ (Romac Plus) Macropad Case

autor ub3rmario · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 95 mm
Odhad tisku
asi 45 g filamentu, 3 h 35 min
Cena u nás
od 192 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

This is a simple drop-in case for the Romac+ macropad. It should with a tiny bit of wiggle room but fairly snug, unless you have overextrusion problems. Mine just barely brushes against the walls as it's dropped into the case. The print is pretty fast even if you use 100% infill, which is what you see in the photos. I also paused twice for this print, to switch to translucent filament then back to black in order to achieve that "shine-through" glowing look for the RGB LEDs. Print in photos created with: • Ender 3 v2 • Tecbears Black and Transparent PLA • 200 degree c nozzle • 60 degree c bed • glass bed • 0.4 mm nozzle

Podobné modely