matplace
Phone Mount  Instrument Cluster Dash Universal Ram Truck & other Vehicles. iPhone 14 Pro fits w/case

Phone Mount Instrument Cluster Dash Universal Ram Truck & other Vehicles. iPhone 14 Pro fits w/case

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití

O modelu

Edit: Just got a iPhone 14 Pro with case and if fits fine.   Hello, this was a much longer build than I anticipated. There are Multiple versions. This mount is made to hold almost any phone up to 150mm tall. but you could always lengthen the model in your slicer for larger phones. You can print with or without the bottom legs. The current models are set up for a 20mm wide trim piece is compatible with my 2019 Ram 1500. Although, there's an endless list of vehicles this will work with. If you have any other vehicle, first thing to do is print one of the legs ("LEGSPRINT2.stl") and adjust (length only) in slicer to where the legs will securely fit on the trim piece in front of your instrument cluster behind the steering wheel. See Picture. Here is a breakdown of available models. SOLIDRAM.stl : [First Picture] This is a complete mount that has "RAM" embossed and legs all in one that will require support to print and some post clean up. (Be careful not to break rear legs during cleanup as it is inset a little from back of mount). SOLIDBLANK.stl : [Second Picture] This is a complete mount with no lettering. If your trim piece is 20mm between clear plastic of your instrument cluster and front of trim, This should work for the vast majority of vehicles. MOUNTNOLEGS: [Third Picture] This is just the mount without the legs. The advantage of this one is it is way quicker print and very little support is needed, but maybe not as pretty as the legs will be exposed more. This will allow you to adjust the legs forward and backward. which sets the angle your phone will be positioned. Print two of the model "LEGSPRINT2.stl" (NOTE: When Legs are oriented correctly, the underside of the mount is smooth across the legs in place, if you have them backwards, the legs will stick out on the bottom a little. • LEGSPRINT2.stl These are the legs, you'll need to print two if you use the "MOUNTNOLEGS.stl" model. I printed with 0.2mm layer height and worked great. I recommend PETG if y

Podobné modely