matplace
Pastamatic - 37 mm motor mount

Pastamatic - 37 mm motor mount

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití

O modelu

This is an barely tested mockup, it seems to work fine but I haven’t run a full spool through it Here’s a link to the motor. I used 8mm m3 screws. https://www.amazon.com/Greartisan-Electric-Reduction-Centric-Diameter/dp/B08D3SSG55/ I don’t intend to develop this motor adapter further, just wanted to share the relevant dimensions in an accessible way in case someone else in the community wants to pick it up To keep with the spirit of the project I’d suggest keeping the cost and variety of non-printed components to a minimum to make the model accessible to as many people as possible. M3 screws, M3 hex nuts, and 608 bearings are preferred

Podobné modely