matplace
Orbital. Structural printing. Print-In-Place lamp

Orbital. Structural printing. Print-In-Place lamp

autor Kagarov · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC-ND (jen nekomerčně, bez úprav)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC-ND (jen nekomerčně, bez úprav)
Největší rozměr
asi 150 mm
Odhad tisku
asi 85 g filamentu, 5 h 20 min
Cena u nás
od 292 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Usually when printing objects they talk about walls and filling, but I made a structure without walls, without filling, and also without a bottom and a cover. There are only bridges that connect and lean on each other. The peculiarity of this project is that it is possible only in 3D printing, it is difficult or impossible to repeat it in traditional technologies, such as injection molding or milling. The lamp looks very complex, but it's easy to print with the usual settings for printing bridges. This printing can be stopped at the end of any layer to obtain a lampshade of the desired height (maximum - 249 mm). Perhaps this project was influenced by Tatlin's impressive tower, Shukhov's hyperboloid, and fantastic orbital structures. I want to use the developed method (for now I called it Structural Printing) in other projects as well. Shade fits IKEA HEMMA lamp and most other pendants with a socket of about 40 mm. Good ventilation (or should you turn off the fan) and not too high speed are needed for printing. Even if several threads break or do not weld, it’s not scary, the design “self-heals” during printing and in the end it turns out to be quite strong (and also a little springy). No post processing required. Do not use bulbs that get very hot. I recommend LED, for example. Check out my project that led me to this https://www.prusaprinters.org/prints/40606-liquid-cuprum-print-in-place-lampshade And also another funny fluffy lamp - Polar Sheep https://www.prusaprinters.org/cs/prints/40124-polar-sheep-lamp Print instructionsFull-height printing time is approximately 8 hours. I was slicing in PrusaSlicer, my old Cura couldn't do the slicing. Since the size of the parts must match the height and width of the layer, changing the scale when printing can lead to an unpredictable result (but you can increase the Z height by a multiple of the layer height, in increments of 0.3 mm per layer, for example, select 0.6). I advise you to print 0.3 layer height and 0.4 layer wi

Podobné modely