matplace
nexus · watering can and cup

nexus · watering can and cup

autor h3li0 · Printables

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 150 mm
Odhad tisku
asi 185 g filamentu, 8 h 40 min
Cena u nás
od 512 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

nexus · watering can and cupthis design comes in two variants, watering can (with a handle) and a smaller watering cup, in a modern minimalist style important · make sure that:your filament is dry and calibrated so that it deals appropriately with the tolerancesyour build plate is properly clean so that there aren't adhesions issues and lifts during the print · if you usually experience issues with bed adhesion on your prints, enable a 5mm brim on the slicerhandle is separate so that the model does not require any supports, and also allows you to print the handle in a different colour if you choose without multicolour wastethe watering can handle as very tight tolerances (0.10mm) to slide into place - you insert it from the bottom side of the can and slide up. There is a pressure fit due to the small tolerances, however i highly recommend that you use glue to secure it into positionboth variants were tested and showed to be water tight with the settings on the 3mf files, also listed below watering can · dimensions in mm (assembled) ~ x:260 · y:107 · z:150watering cup · dimensions in mm ~ x:133 · y:75 · z:105 photos show printed in matte pla.40mm nozzleadaptive layer height3 walls15% gyroid infill on the can and 25% gyroid infill on the handlenotesincludes bambu studio 3mf files and STLsall photos uploaded are of the actual printed model, and are copyright protectedif you enjoy this model please consider to buy me a coffeecommercial licence membership available on my patreon

Podobné modely