Moopsy: The Cuddly Bone-Vampire from Star Trek
MakerWorld
Vytiskněte si ho pro sebe
Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.
Nahrát soubor a vytisknout- Licence
- jen pro osobní použití
O modelu
Change log: • 9/12/23: Added photos of my make, and uploaded a STEP version. • 9/13/23 (midnight): Added a multi-part version and instructions. Requires glue, but you only need a black sharpie/paint and single-color printing instead of fancy multi-color printing. • 9/13/23 (actual morning): Drastically improved and simplified instructions and model so that one multi-part model should serve everyone's needs. Updated STEP file too. This also will improve multi-color printing ease and final product significantly due to slicer glitches with the earlier model. • 9/19/23: Smaller head version now available here for people who prefer this look. Moopsy was first seen in the episode “I Have No Bones Yet I Must Flee” of Star Trek: Lower Decks, where it caused havoc in a galactic menagerie. Moopsy is one of the most terrifying aliens ever introduced in Star Trek, despite its cute appearance. I could not help myself by try to replicate this creature. I'm a total novice at Fusion360, but I tried my best to produce a faithful looking replica… with way too much effort. I actually think it looks pretty decent. Requires some supports, as shown. Printed here in 4-color PLA on my X1C to match the picture shown above from the show. You could probably just print it all one color though and paint it. Flavor text I made for this critter: Moopsy is a small, furry alien with big eyes and a round body. It looks harmless and adorable, but it has a hidden ability to launch itself at high speed towards its prey and sink its sharp teeth into them. Moopsy drains the bones of its victim, leaving behind a boneless sack of flesh. Moopsy is very hungry and will chase after any food source relentlessly. How To Print Multi-color (MMU/AMS): • Supports are needed. Sit him on the designed-in flat butt area, as shown. • I designed it to minimize the amount of support needed. I used snug supports and PETG as an interface layer, but organic supports should work well here. • 0.2 mm layer height. A
Podobné modely
Buzz Lightyear Multipart Fanart
matplace
Cat
MakerOnline · Yang3D(
Stitch NO AMS
matplace
Streetwear Bowser Figure | Super Mario Urban Fan Art
Printables · Fluid Prints
Tom Cat
matplace
Flexi Factory and Bambu Lab Collaborative: Panda Bear and Stand
MakerWorld · flexi.factory
