matplace
Moon Lamp (Commercial Use Allowed)

Moon Lamp (Commercial Use Allowed)

autor Artificial World · Printables

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 150 mm
Odhad tisku
asi 284 g filamentu, 10 h 12 min
Cena u nás
od 677 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Please read the entire text before printing! I often make the mistake of not doing so. If you like the model, consider supporting my future projects: https://boosty.to/artificialworld/donate. 1. Model: Moon Appr. diameter: 210 mm Surface: Moon Displacement Map + Moon Color Map (Lithophane). Both from NASA Adapter Important note: I use a tiny USB light (link to Amazon USB light) with a USB extension cable (link to Amazon USB extension cable), so that my adapter only needs a hole for a cable. You may need to look at "LightPlacement (BetterFit).stl" to edit it according to your own needs Opening diameter: 58 mm. This means that you can fit a cylinder with a 58 mm diameter inside the lamp Connection type: Bayonet Connection Maximum slope of overhangs: 45 degrees. Thus, you will face no issues with overhangs Tolerances were tested thoroughly, so the adapter fits easily Stand Appr. width: 180 mm Appr. height: 58 mm 2. Printing Instructions: I printed the Moon Lamp with a Flashforge Adventurer 5M with 0.4 mm nozzle Moon Recommended material: Basic white PLA Layer height: 0.2 mm Sparse infill density: 100% Brim type: Outer and inner brim Brim width: 65 mm. You can print it without a brim, but I had a problem when the printing was almost finished, so next time I set the brim to maximum Adapter ring modifier (optional, but saves a lot of material): Sparse infill density: 5% Sparse infill pattern: Grid Everything else is default orca slicer settings. Adapter Halves Recommended material: Basic white PLA Layer height: 0.2 mm Sparse infill density: 5% Sparse infill pattern: Grid Optional (Improves adhesion to the plate): Brim type: Outer brim only Brim width: 5 mm Everything else is default orca slicer settings Stand Recommended material: Brown PLA with 15% wood Layer height: 0.2 mm Sparse infill density: 5% Sparse infill pattern: Grid Position below plate: 1.05 mm. This increases the bottom surface area Fuzzy skin: Contour Fuzzy skin noi

Podobné modely