matplace
Magnet Organizer

Magnet Organizer

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 140 mm
Odhad tisku
asi 185 g filamentu, 7 h 0 min
Cena u nás
od 462 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

After starting to delve deep into the hobby of 3D printing, I realized magnets are fairly frequently used. After I purchased some that came all stuck together in a single plastic box, I designed this. It's nothing special, but hopefully someone can use it.   The lid slides from top down and may take a couple of ins and outs before it'll slide in smoothly as it was sized to fit nearly perfectly.   Model in photos was printed with Hatchbox Matte Grey PLA. Both lid/case oriented flat side down with no supports. My slicer (bambu) suggested supports for the numbers, but I had no issues with the overhangs on my Bambu P1P. Your experience may vary.   Note: If there are any other commonly used sizes of magnets that you think should be added to the design, let me know.

Podobné modely