One Ring - Dual Print and Lithophane - Hueforge Print
MakerWorld · cyanidesugar
autor RetromanIE · Printables
Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.
Nahrát soubor a vytisknoutThese are mainly for use with the lithophanes available on Gadunky.com(but work on anything that will fit in them). They hold the lithophane at an 80° angle for best viewing(the flat section with the curve should be facing the back). Print with 100% infill in whatever material and colour you like(tested with PLA, PETG and ABS). A layer height of 0.2mm is a good balance between quality and print time on these. The height of the lithophane must also be considered when using a stand. These have been designed to comfortably hold a lithophane with a height 1.75x the length of the stand. So the 180mm version should hold a lithophane with a height of 315mm(180mm+75%) without falling over. In practice it will hold a much taller lithophane than this, but we only recommend up to 1.75x the length. If you need a particular size just comment and I'll add them. I need to know the length of the lithophane, thickness and how tall it will be. File name breakdown:- LithoStand-Gadunky.com-v3b-3.2mm-200mm.stl v3b: Version 3b of the stand design. 3.2mm: For use with 3.2mm thick lithophanes. 200mm: For use with 200mm in length (or smaller) lithophanes. All files follow this naming format. . Print instructions0.2mm layer height is perfectly fine for these. 100% infill,
MakerWorld · cyanidesugar
matplace
MakerWorld · 3DPrintBunny
Printables · MeasureOnce
MakerWorld
Printables · Carl D
Printables · RetromanIE
Printables · LMF5000
Cookies a měření. Nezbytné cookies jsou vždy; měření návštěvnosti a reklamy jen s vaším souhlasem. Víc o cookies