matplace
Lithophane Stand USB Light 180mm

Lithophane Stand USB Light 180mm

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 180 mm
Odhad tisku
asi 89 g filamentu, 6 h 52 min
Cena u nás
od 343 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Oct 19 2004 Update Description Updating this old post with more revelvant information. Lithophanes were made on https://3dp.rocks/lithophane/ website and I believe the sizing for these mounts are 180mm curve with a 3mm thickness. Awhile back I bought a few right angle USB adapters (picture above) and redesign an old version of my stand to utilize them. I also added a little USB logo cuz why not. These adapters are used with the “LithStand_LowPro.stl” Then I added another version that only uses USB cable “LithStand-USB" and “LithStand-USBv2." The 2nd version of this design brings the LED light in a little closer to the lithophanes for ones that dont have as much height to avoid seeing the led poking out above it. This is about as close as I could go before the lighting would start creating hot spots and not fully illuminate the entire thing.  These are the USB Lights I'm Using from Amazon. They come in different warmth's and use a touch panel on back to turn on/off (tap) or dim (press and hold). Hopefully this helped someone else out!Boost MeBoost if it has helped!

Podobné modely