matplace
iPhone Stand works with Case to mount under iMac on the base

iPhone Stand works with Case to mount under iMac on the base

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 150 mm
Odhad tisku
asi 42 g filamentu, 1 h 35 min
Cena u nás
od 128 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Using Sergio Angeriz's excellent design as a starting point, https://www.printables.com/social/93377-sergio-angeriz I modified the iPhone holder to mount under my iMac. I am not sure what computer models it will fit. Mine is a 24' iMac "M1" from 2021. The iMac base is approximately 130mm wide and 6mm tall. Also, my phone is a iPhone 14 Pro with a case. I believe an iPhone Max will fit as long as you don't have the monitor angle straight up and down. I laid the phone angle back a few degrees from the original model to allow the phone angle to match my preferred computer screen angle. I am sure lots of different types of phones will fit as spacing generous. It's a good fit, however if you'd like it to be rock solid, I recommend using a tiny bit of Blu-Tac / Fun-Tak. https://a.co/d/bMi0A7v Phones 13mm or thinner should fit well. God Bless, Casey

Podobné modely