matplace
Gear fidget ring print in place

Gear fidget ring print in place

autor Thorin Oakenshield · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 22 mm
Odhad tisku
asi 8 g filamentu, 45 min
Cena u nás
od 85 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Relaxation ring with a gear wheel, print in place If the ring is difficult to fit, run it under water, push it to twist in all directions, it helped me a lot In g-code, a collar is set around so that the model does not come off - I recommend adding a collar because the outer part of the ring has only 2 perimeters I created the ring in three sizes - with a 19, 18, 17 mm hole Other similar gear spinners can be found in my spinner collection:   https://www.printables.com/cs/@ThorinOakenshield/collections/388544?o=newest  

Podobné modely