matplace
Corner Clamp (ClampItSquare)

Corner Clamp (ClampItSquare)

autor The Redcoat · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 110 mm
Odhad tisku
asi 145 g filamentu, 5 h 20 min
Cena u nás
od 364 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Remix of a design by J-Max from https://www.thingiverse.com/thing:1306832 These are corner square clamps in 30 variations used for woodworking to hold two pieces 90 degrees square during a glue-up or pocket-hole join. Regular clamps of many types can be used on this to provide pressure. The original design had just 3 models and two reported issues (detailed below) and has since attracted many more suggestions & comments from Printables users on the v1 models, most of which are addressed in the v2 model set. Aggh, it's just a square - why so many models? Unlike many models where you can just scale them in slicer to fit your needs, this one works a lot better pre-scaled. For example, if you make a fat square thinner, the chamfer angles can change to be unprintable without supports. If you make a thin square fatter, the enlarged chamfers waste a lot of good internal clamping surface. So, there are now 5 main models: Mini, Medium, Large, LargeVR and Max. Most have 3 thicknesses, 2", 3", 4", and for each of those, you will find both flat and anti-elephant-foot versions (see below for why). V2: 2023-02 Version (Latest) Mini, Medium & Large were re-mastered in FreeCAD, fixing minor geometry issues with the internal clamp hole, and producing much cleaner smaller models, about 15-20% the size of the OpenSCAD v1s. Addresses the suggestions raised by CaptAngry, adesir, zzet, and noted by w00h to add a small chamfer around the XY plane perimeter to eliminate the threat of elephants-foot impacting the clamping surface. I've never seen this myself, and it could be fixed with sandpaper, but everyone uses different printers and slicer configurations and a model should be as printable as it can be. These models end with "AntiEF", vs the other version "Flat" which will be very slightly easier to print. Addresses the issue demonstrated by vinz972 that taller versions of the squares would be useful when clamping wood beyond 2" tall. The original squares are 28mm or 35mm high (for

Podobné modely