matplace
Cable Organizer

Cable Organizer

autor Nordheim · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 110 mm
Odhad tisku
asi 48 g filamentu, 2 h 36 min
Cena u nás
od 166 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Edit: Updated the V2 base to make it easier to remove → V2.1 Installation Attach the base with two screws. Then sling the cables around it and snap the cover in place. Printing I added a new version with wider clips that prints without supports.  The base prints on the side. I used PETG for this part The Cover prints as shown below. I used PLA for this part.

Podobné modely