matplace
Airplane print in place

Airplane print in place

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití

O modelu

Beautiful one piece airliner print. You can choose version without stand mounting holes, or version with stand mounting holes. There are also stand model for the plane.     Print settings -Nozzle 0,4 mm -Layer height 0,12 mm -Perimeters/wall line count 3 -Infill 20%   Print instructions -Find out best Z-seam setting for hiding the seam -Raise the model lowest point 2 mm above build plate, you may change your slicer setting to allow that. (See picture how to switch that setting in Cura) -Recommended model alignment exactly horizontal. (See picture from slicer) -If stand mounting pins fit too loose, you can use some glue, or tweak your slicer settings -Use support blocker below plane stand mounting holes if printing stand version   Minimum build plate size: 203 mm x 175 mm   Please ask if you have any questions or improvement suggestions!

Podobné modely