matplace
Adjustable Airplane Phone Holder

Adjustable Airplane Phone Holder

autor SquidgyPlastic · Printables

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 85 mm
Odhad tisku
asi 18 g filamentu, 1 h 35 min
Cena u nás
od 100 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

I do a reasonable amount of flying for work and it has always been a pain holding or propping up my phone so I can watch movies. I tried some low-tech methods over the years but this design is my current solution. I got inspiration for this from the following design https://www.thingiverse.com/thing:3129751 but after trying it a few times I wanted something more adjustable. I designed a similar way of attaching the holder to the seat and griping the phone but with adjustability in mind. The only extra hardware is an M3 nut and bolt (30mm long) for the adjustment knob.  I have used this now for a good few flights and can report it works well. The adjustable angle works well especially when the seat in front is reclined as well as the adjustable tray grip. Printed with a 0.2mm layer height in shocking Prusa orange PETG so I can see it when it ends up on the floor. The OpenSCAD file should be adjustable should this not meet your needs but I have not tested other dimensions. Some supports are required but I have built that into the script.

Podobné modely